• Welcome to H4O! For a reduced ad experience, please login or register with the forum.

What did you do with your H3 recently? NEW

Traxx

Well-Known Member
Messages
682
Location
PNW
Picked up a pack 68ohm of resistors to fix the annoying one click off cold, full heat issue.
 

deserth3

Well-Known Member
Messages
1,079
Location
Conroe, TX
Did a little modification to my roof marker lights.
35104833ecbe7dbab06b607ea961227b.jpg


Sent from my Moto G (4) using Tapatalk
Well that didn't last long. Noise was terrible. Have to look for something with a low, thin profile.
Might not have been so bad if I didn't have the sun roof. Or if I put them directly onto the roof. But I'm not ready to put more holes in my truck just yet.

Sent from my Moto G (4) using Tapatalk
 
Last edited:

jakesz28

Well-Known Member
Messages
1,056
Location
Cabool MO
The new winch is mounted, installed a new rear driveshaft. Front license plate is now on wire ties, since I removed the roller fairlead and now have an aluminum one. I would like to say I lost some weight with the synthetic line, but that's not the case. The winch was stronger/heavier.
 

RamRod

Well-Known Member
Messages
3,914
Location
AB, Canada
More progress in the new roof rack
Here are some teaser pics, head over to the build thread for more details
3a0bc31f3389b0ba178b9e90e643b430.jpg
ef74a0f3c03c0e84c6808e4d4f85b677.jpg
cedeffbdccb742aae92fca40e279f116.jpg


Sent from my SM-G935W8 using Tapatalk
 

Panzer07

Well-Known Member
Messages
2,548
Location
Ontario, CA
Working on bumper armor 1/4" steel I believe it should provide enough protection I think, and hopefully strong enough to hold my custom rino hmmvw's spare tire carrier.

And as usual panzer's sister Valkyrja Assisted Bringing panzer's Goodies home (yes those are 4 1/4" sheets 5'5"x9" made ride a little awkward and leaned hahaha).
125b59b65adb4c7b76416183ba6734ff.jpg
db8ae7e41ff401b5537b2b3ba090ebaa.jpg


Sent from my SM-G930T using Tapatalk
 

awalsh

Well-Known Member
Messages
349
Location
New Jersey
f48ca3e431369aacd3749c91b667c483.jpg

Tested out the new snorkel today! Half kidding.. But installed some hella horns, not as loud as I had hoped for but better than oem.


Sent from my iPhone using Tapatalk
 

scoreh3

Well-Known Member
Messages
1,024
Location
SoCal
Looks nice ! I hope the snorkel test went well . What Hella horns did you get . I was looking at the twin red round Hellas .
 

Panzer07

Well-Known Member
Messages
2,548
Location
Ontario, CA
Well almost finish with this project...now to decide on angle or curbed bottom corners
2089f581cdf918fc891b6fe938fb35ef.jpg
e798b40cca36596921cd3178cf5b68c6.jpg
e50ea95544ebeba1ef950783efa94e0b.jpg


Sent from my SM-G930T using Tapatalk
 

H3TDave

Well-Known Member
Messages
111
Location
West Virginia
Looks like I'll be replacing front brakes and rotors this evening. Pads were shot and rotors are heat cracked. And thanks to this anti rattle clip one is nice and grooved.
ac61371306729aac22ace8aaeceef379.jpg


Sent from my SAMSUNG-SM-G891A using Tapatalk
 

H3TDave

Well-Known Member
Messages
111
Location
West Virginia
It was painful to watch and listen to. I was about half listening to it but when I looked up to him splitting the caliper my mind was blown.

Sent from my SAMSUNG-SM-G891A using Tapatalk
 

CaseyS

Well-Known Member
Messages
755
Location
Louisiana
Hadn't put 400 miles on a tank in a while. Mostly because the station around the corner has diesel $0.20 cheaper than anywhere else and I usually fillup when I pass it regardless of how empty it is. Usually never less than 1/4 tank and around 340 miles on the tank. Got a nice hot batch of fuel the other day and made just over 21.1 MPG on a road trip to Arkansas. This fillup was 19.6 gallons.

 

High Five H2

Well-Known Member
Messages
1,627
Location
West Texas
Me the night before a wheeling trip: "I'm totally getting this done right after work and leaving early."

Also me at midnight:

b7013d288808045e16047f099fbafe2e.jpg



Sent from my iPhone using Tapatalk
 
Top