Search results

Appreciate the reply. I will do this thanks a lot! I think so also. Looks like I am just going to wait. The bolt is seized that goes into the flexible line. I've tried pb, heat, a vice and a few smacks with a hammer. Went shopping locally for a flexible line no one has them in stock. I will...

I need to replace one of my rear axle brake hardlines for my 2009 H3T. I cannot find an exact replacement and to be honest I don't want to bend and flare my own. What are you guys doing to replace these? I wasnt sure if the runs would be too long for a flexible hose. I was going to order this...

Thanks for the reply! That's exactly what I did. I used a ratchet strap to the seat from to the wheel. I finally got the new one in Sunday, it had to be shoved all the way to the right then turned slightly back. I did not end up pushing the diff back but for future reference I definitely will...

Code shows that it'll be on circuit two. If you can find a diagram it can be helpful for reference. Also check all your fuses.

You'll find one ( facing the engine ) near the left back side near your fuel rails. The other runs on the battery side. Make sure your wire lume is in decent shape check the areas that look rough. I sure hope this helps!

I'm gonna get back to the Tetris game after work and take the tie rods off. I appreciate the response for the o rings. I have an assortment of high pressure o rings I will use then thanks a lot!

Check your wire harness on both sides of engine. I had a similar issue a few years ago. Turned out to be the smallest short on the wire harness from rubbing against a bolt.

Im in the process of putting in a new mando rack and outfitter design reinforement kit in my alpha. I have the rack completely free, tires off slightly lifted off the ground. I am having one heck of a time getting the old rack out. I started taking lines off the old rack just to try and get it...